Dell Force10 S4810P Reference Manual page 1335

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 S4810P:

Table of Contents

Command Modes

Command History

Version 6.5.1.0

FTOS#sh cam layer3-qos interface gigabitethernet 2/1

Cam Port Dscp Proto Tcp Src

-----------------------------------------------------------

FTOS#show cam layer3-qos linecard 13 port-set 0

---------------------------------------------------------------

Example (Without

FTOS#sh cam layer3-qos interface gigabitethernet 2/1

Enter the keyword interface followed by one of the keywords

below and slot/port or number information:

(OPTIONAL) Enter the keyword summary to display only the total

number of CAM entries.

Introduced on the E-Series.

The entry TRUST-DSCP in the Queue column indicates that the trust diffserv is

configured on the policy-map.

A hyphen (-) entry in the DSCP Marking column indicates that there is no DSCP

In the Proto column (Protocol), IP, ICMP, UDP, and TCP strings are displayed. For

other protocols, the corresponding protocol number is displayed.

Flag Port Port

Port Dscp Proto Tcp

Port Dscp Proto Tcp

For a Fast Ethernet interface, enter the keyword

FastEthernet followed by the slot/port information.

For a Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a SONET interface, enter the keyword sonet followed by

the slot/ port information.

For a Ten Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

Flag Port Port

1.0.0.1/24 2.0.0.2/24-

8.0.0.8/24 8.0.0.8/24 23 3

Flag Port Port

0.0.0.0/0-TRUST-DSCP