Dell Force10 S4810P Reference Manual page 1285

To remove PVLAN mode from the selected port, use the no switchport mode
private-vlan command.
Parameters
host
promiscuous
trunk
Defaults Disabled.
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Usage
The assignment of the various PVLAN port types to port and port channel (LAG) interfaces is
Information
shown below.
Example
FTOS#conf
FTOS(conf)#interface GigabitEthernet 2/1
FTOS(conf-if-gi-2/1)#switchport mode private-vlan promiscuous
FTOS(conf)#interface GigabitEthernet 2/2
FTOS(conf-if-gi-2/2)#switchport mode private-vlan host
FTOS(conf)#interface GigabitEthernet 2/3
FTOS(conf-if-gi-2/3)#switchport mode private-vlan trunk
FTOS(conf)#interface port-channel 10
FTOS(conf-if-gi-2/3)#switchport mode private-vlan promiscuous
Related
private-vlan mode
Commands
private-vlan mapping secondary-vlan
then associates the secondary VLANs to it.
show interfaces private-vlan
show vlan private-vlan mapping
Enter the keyword host to configure the selected port or port
channel as an isolated interface in a PVLAN.
Enter the keyword promiscuous to configure the selected port or
port channel as an promiscuous interface.
Enter the keyword trunk to configure the selected port or port
channel as a trunk port in a PVLAN.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
– sets the mode of the selected VLAN to community, isolated, or primary.
– sets the mode of the selected VLAN to primary and
– displays type and status of PVLAN interfaces.
– displays the primary-secondary VLAN mapping.
1285