Stack-Unit Priority; Stack-Unit Provision - Dell Force10 S4810P Reference Manual

stack-unit priority

Configure the ability of an S-Series switch to become the management unit of a stack.
S-Series
Syntax stack-unit 0-7 priority 1-14
Parameters
0–7
1–14
Defaults 0
Command Modes CONFIGURATION
Command History
Version 7.7.1.0
Related
Commands

stack-unit provision

Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the
management unit.
S-Series
Syntax stack-unit 0-11 provision {S25N|S25P|S25V|S50N|S50V|S4810}
1524
• show hardware stack-unit
output statistics of the designated component of the designated stack member.
• show system (S-Series)
member.
• upgrade (S-Series management unit)
of the S-Series management unit.
Enter the stack member unit identifier, from 0 to 7, of the switch on
which you want to set the management priority.
This preference parameter allows you to specify the management
priority of one backup switch over another, with 0 the lowest priority
and 14 the highest. The switch with the highest priority value is
chosen to become the management unit if the active management
unit fails or on the next reload.
Introduced on the S-Series.
• reload – reboots FTOS.
• show system (S-Series)
member.
– displays the data plane or management plane input and
– displays the current status of all stack members or a specific
– upgrades the bootflash image or system image
– displays the status of all stack members or a specific