Dell Force10 S4810P Reference Manual page 861

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)
Hide thumbs Also See for Force10 S4810P:
Table of Contents

Advertisement

distance
permanent
tag
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.9.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage
Using the following example of a static route: ip route 33.33.33.0 /24 gigabitethernet 0/0
Information
172.31.5.43
Related
show ip route
Commands
(OPTIONAL) Enter a number as the distance metric assigned to the
route. The range is 1 to 255.
(OPTIONAL) Enter the keyword permanent to specify the route is
not removed, even if the interface assigned to that route goes down.
The route must be up initially to install it in the routing table.
tag-value
(OPTIONAL) Enter the keyword tag followed by a number to assign
to the route. The range is 1 to 4294967295.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Added support for 4094 VLANs on the E-Series ExaScale (the prior
limit was 2094).
Introduced on the E-Series ExaScale.
Introduced VRF on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
The software installs a next hop that is not on the directly connected subnet but which
recursively resolves to a next hop on the interface's configured subnet. In the example,
if gig 0/0 has an ip address on subnet 2.2.2.0 and if 172.31.5.43 recursively resolves to
2.2.2.0, FTOS installs the static route.
When the interface goes down, FTOS withdraws the route.
When the interface comes up, FTOS re-installs the route.
When recursive resolution is "broken," FTOS withdraws the route.
When recursive resolution is satisfied, FTOS re-installs the route.
– views the switch routing table.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
861

Advertisement

Table of Contents
loading

Table of Contents