Interface Loopback; Interface Managementethernet - Dell Force10 S4810P Reference Manual

show interfaces

interface loopback

Configure a Loopback interface.
C-Series, E-Series, S-Series, Z-Series
Syntax interface loopback number
To remove a loopback interface, use the no interface loopback number command.
Parameters
number
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.4.1.0
Example
FTOS(conf)#interface loopback 1655
FTOS(conf-if-lo-1655)#
Related
interface
Commands
interface null
interface port-channel
interface vlan

interface ManagementEthernet

Configure the Management port on the system (either the Primary or Standby RPM).
C-Series, E-Series, S-Series, S4810, Z9000
Syntax interface ManagementEthernet slot/port
Parameters
slot/port
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
– displays the interface configuration.
Enter a number as the interface number. The range is 0 to 16383.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
– configures a physical interface.
– configures a Null interface.
– configures a port channel.
– configures a VLAN.
Enter the keyword ManagementEthernet followed by slot
number (0-1) and port number zero (0).
Introduced on the Z9000.
769