Dell Force10 S4810P Reference Manual page 885

Lines
TenGigabitEthernet
0/0...
Internet address...
IP MTU is...
Inbound access...
Proxy ARP...
Split horizon...
Poison Reverse...
ICMP redirects...
ICMP
unreachables...
Example
FTOS#show ip int te 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
FTOS#
Usage The following describes the show ip interface brief command shown in the
Information
Example below.
Fields
Interface
IP-Address
Ok?
Method
Status
Protocol
Example (Brief)
FTOS#show ip int brief
Interface
Status
GigabitEthernet 1/0
Description
Displays the interface's type, slot/port, and physical and line protocol
status.
States whether an IP address is assigned to the interface. If an IP
address is assigned, that address is displayed.
Displays IP MTU value.
Displays the name of the any configured incoming access list. If
none is configured, the phrase "not set" is displayed.
States whether proxy ARP is enabled on the interface.
States whether split horizon for RIP is enabled on the interface.
States whether poison for RIP is enabled on the interface.
States if ICMP redirects are sent.
States if ICMP unreachable messages are sent.
Description
Displays type of interface and the associated slot and port number.
Displays the IP address for the interface, if configured.
Indicates if the hardware is functioning properly.
Displays "Manual" if the configuration is read from the saved
configuration.
States whether the interface is enabled (up) or disabled
(administratively down).
States whether IP is enabled (up) or disabled (down) on the
interface.
IP-Address OK? Method
Protocol
unassigned NO Manual administratively
885