Show Mac-Address-Table Aging-Time - Dell Force10 S4810P Reference Manual

Column Heading
State
Example
FTOS#show mac-address-table
VlanId Mac Address
999
999
FTOS#
Usage The following describes the show mac-address-table count command shown in the
Information
Example below.
Line Beginning With
MAC Entries...
Dynamic Address...
Static Address...
Total MAC...
Example (Count)
FTOS# show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count :
Static Address (User-defined) Count : 0
Sticky Address Count :
Total Synced Mac from Peer(N):
Total MAC Addresses in Use:
FTOS#
Related

show mac-address-table aging-time

Commands
show mac-address-table aging-time
Display the aging times assigned to the MAC addresses on the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show mac-address-table aging-time [vlan vlan-id]
Parameters
vlan
Command Modes
1044
Description
•
•
•
Lists if the MAC address is in use (Active) or not in use (Inactive).
00:00:00:00:00:19 Sticky
00:00:00:00:00:29 Dynamic Gi 0/2
Description
Displays the number of MAC entries learnt per VLAN.
Lists the number of dynamically learned MAC addresses.
Lists the number of user-defined MAC addresses.
Lists the total number of MAC addresses used by the switch.
vlan-id
(OPTIONAL) Enter the keyword vlan followed by the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1 to
4094.
• EXEC
• EXEC Privilege
po — Port Channel followed by a number. The range is 1 to
255 for TeraScale.
so — Sonet followed by a slot/port.
te — 10-Gigabit Ethernet followed by a slot/port.
Type Interface State
Gi 0/1
110
0
100
110
– displays MAC aging time.
Active
Active