Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage
To enable RIP, you must assign a network address using the network command.
Information
Example
FTOS(conf)#router rip
FTOS(conf-router_rip)#
Related
network
Commands
exit
show config
Display the changes you made to the RIP configuration. Default values are not shown.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes
ROUTER RIP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Example
FTOS(conf-router_rip)#show config
!
router rip
FTOS(conf-router_rip)#
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enables RIP.
– returns to CONFIGURATION mode.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
network 172.31.0.0
passive-interface GigabitEthernet 0/1
1371