Show Ip Pim Snooping Neighbor - Dell Force10 S4810P Reference Manual

Field
Nbr Count
DR Prio
DR
Example (#2)
FTOS#show ip pim snooping interface
Interface Ver Nbr
Vlan 2

show ip pim snooping neighbor

Display information on PIM neighbors learned through PIM-SM snooping.
E-Series ExaScale, S4810
Syntax show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan
Command Modes
Command History
Version 8.3.12.0
Version 8.4.1.1
Usage The following describes the show ip pim snooping neighbor commands shown in
Information the Example below.
Field
Neighbor address
Interface
Uptime/expires
Description
•
•
Displays the number of neighbors learned through PIM-SM snooping
on the interface.
Displays the Designated Router priority value configured on the
interface (ip pim dr-priority command).
Displays the IP address of the Designated Router for that interface.
Count
v2 3
vlan-id
(OPTIONAL) Enter a VLAN ID to display information about PIM
neighbors that was discovered by PIM-SM snooping on a specified
VLAN. The valid VLAN IDs range is 1 to 4094.
• EXEC
• EXEC Privilege
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Description
Displays the IP address of the neighbor learned through PIM-SM
snooping.
Displays the VLAN ID number and slot/port on which the PIM-SM-
enabled neighbor was discovered.
Displays the amount of time the neighbor has been up followed by
the amount of time until the neighbor is removed from the multicast
routing table (that is, until the neighbor hold time expires).
v2 = PIM version 2
S = PIM Sparse mode
DR DR
Prio
1 165.87.32.2
1251