Channel-Member - Dell Force10 S4810P Reference Manual

Because each port can be assigned to only one Port Channel, and each Port Channel must have at least one port, some
of those nominally available Port Channels might have no function because they could have no members if there are not
enough ports installed. In the S-Series, those ports could be provided by stack members.
NOTE: The FTOS implementation of LAG or Port Channel requires that you configure a LAG on both switches
manually. For information about FTOS link aggregation control protocol (LACP) for dynamic LAGs, refer to the
Aggregation Control Protocol (LACP)
FTOS Configuration Guide .
refer to the

channel-member

Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface
command.
Parameters
interface
Defaults Not configured.
Command Modes INTERFACE PORTCHANNEL
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Usage
Use the interface port-channel command to access this command.
Information
chapter. For more information about configuring and using Port Channels,
(OPTIONAL) Enter any of the following keywords and slot/port or
number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Link
819