Ipv6 Basics; Clear Ipv6 Fib; Clear Ipv6 Route - Dell Force10 S4810P Reference Manual

IPv6 Basics

IPv6 Basic Commands are supported on Dell Force10 E-Series, C-Series, S-Series, Z-Series, or S4810 platforms.
NOTE: For information about the Force10 operating software (FTOS) version and platform that supports IPv6 in each
software feature, refer to the "IPv6 Addressing" chapter of the

clear ipv6 fib

Clear (refresh) all forwarding information base (FIB) entries on a linecard or stack unit.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax clear ipv6 fib linecard slot | stack-unit unit-number
Parameters
slot
unit-number
Command Modes EXEC Privilege
Command History
Version 9.0.0.0
Version 8.3.7.0
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0

clear ipv6 route

Clear (refresh) all or a specific route from the IPv6 routing table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax clear ipv6 route {* | ipv6-address prefix-length}
FTOS Configuration Guide .
Enter the slot number to clear the FIB for a linecard.
Enter the stack member number.
The rang is 0 to 7 for the Z9000 and 0 to 11 for the S4810.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
27
935