Ip Route - Dell Force10 S4810P Reference Manual

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 S4810P:

Table of Contents

This command is available for physical interfaces and port-channel interfaces on the E-Series.

ip route

Assign a static route to the switch.

C-Series, E-Series, S-Series, Z-Series, S4810

ip route vrf {vrf instance} destination mask {ip-address |

interface [ip-address]} [distance] [permanent] [tag tag-value]

To delete a specific static route, use the no ip route destination mask

{address | interface [ip-address]} command.

To delete all routes matching a certain route, use the no ip route destination

mask command.

Introduced on the E-Series.

NOTE: This command is not supported on default VLAN (the default vlan-id

(OPTIONAL) E-Series Only: Enter the keyword vrf followed by the

VRF Instances name to tie the static route to the VRF instance.

Enter the IP address in dotted decimal format of the destination

Enter the mask in slash prefix formation (/x) of the destination

device's IP address.

Enter the IP address in dotted decimal format of the forwarding

Enter the following keywords and slot/port or number information:

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a loopback interface, enter the keyword loopback

followed by a number from zero (0) to 16383.

For the null interface, enter the keyword null followed by

For a Port Channel interface, enter the keyword port-

channel followed by a number. For the C-Series and S-

Series, the range is 1 to 128. For the E-Series, the range is 1 to

255 for TeraScale and 1 to 512 for ExaScale.

For a SONET interface, enter the keyword sonet followed by

the sonet followed by the slot/port information.