Version 6.1.1.0
Usage
The output of the show interfaces command displays the configured rate interval, along
Information
with the collected traffic data.
Related
show interfaces
Commands
show config
Display the interface configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes
INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Example
FTOS(conf-if)#show conf
!
interface GigabitEthernet 1/7
FTOS(conf-if)#
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (interface range).
C-Series, E-Series, S-Series, Z-Series
Syntax
show config
Command Modes
CONFIGURATION INTERFACE (conf-if-range)
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Introduced
– displays information on physical and virtual interfaces.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
no ip address
switchport
no shutdown
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
787