Protocol-Tunnel Rate-Limit; Show Protocol-Tunnel - Dell Force10 S4810P Reference Manual

protocol-tunnel rate-limit

Enable traffic rate limiting per box.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate
command.
Parameters
rate
Defaults 75 frames per second.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.4.1.0
Example
FTOS#
FTOS#conf
FTOS(conf)#protocol-tunnel rate-limit 1000
FTOS(conf)#
Related

show protocol-tunnel

Commands
show running-config
show protocol-tunnel
Display protocol tunnel information for all or a specified VLAN-Stack VLAN.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show protocol-tunnel [vlan vlan-id]
Parameters
vlan
Defaults none
Command Modes EXEC
Enter the rate in frames per second. The range is 75 to 3000. The
default is 75.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series, E-Series Terascale, and E-Series
ExaScale. Maximum rate limit on E-Series reduced from 4000 to 3000.
Introduced
– displays tunneling information for all VLANs.
– displays the current configuration.
vlan-id
(OPTIONAL) Enter the keyword vlan followed by the VLAN ID to
display information for the one VLAN. The range is 1 to 4094.
1465