Match Ip Dscp - Dell Force10 S4810P Reference Manual

Parameters
access-group-
name
set-ip-dscp
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
Version 8.3.11.1
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage You must enter the class-map command in order to access this command. After the class
Information map is identified, you can configure the match criteria. For class-map match-any, a maximum
of five ACL match criteria are allowed. For class-map match-all, only one ACL match
criteria is allowed.
Related
class-map
Commands

match ip dscp

Use a differentiated services code point (DSCP) value as a match criteria.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax match ip dscp dscp-list [[multicast] set-ip-dscp value]
To remove a DSCP value as a match criteria, use the no match ip dscp dscp-list
[[multicast] set-ip-dscp value] command.
Parameters
dscp-list
multicast
1316
Enter the ACL name whose contents are used as the match criteria in
determining if packets belong to the class specified by class-map.
value
(OPTIONAL) Enter the keywords set-ip-dscp followed by the IP
DSCP value. The matched traffic is marked with the DSCP value. The
range is 0 to 63.
Introduced on the Z9000.
Introduced on the Z9000.
Introduced on the S4810.
Added the DSCP Marking option support on the S-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the DSCP Marking option.
Introduced on the E-Series.
– identifies the class map.
Enter the IP DSCP value(s) that is to be the match criteria. Separate
values by commas — no spaces ( 1,2,3 ) or indicate a list of values
separated by a hyphen (1-3). The range is 0 to 63.
(OPTIONAL) Enter the keyword multicast to match against
multicast traffic.
NOTE: This option is not supported on C-Series or S-Series.