Queue Ingress - Dell Force10 S4810P Reference Manual

Command History
Version 8.3.8.10
Version 7.5.1.0
Version 7.4.1.0
and 6.5.3.0
Usage This command does not uniquely identify a queue, but rather identifies only a set of queues.
Information The WRED curve is applied to all eight egress Multicast queues.
Important Points to Remember — Multicast-Bandwidth Option
Related show queue statistics egress
Commands

queue ingress

Assign a WRED Curve to all eight ingress Multicast queues or designate the percentage for the Multicast bandwidth
queue.
E-Series, S4810
Syntax queue ingress multicast {linecard slot number port-set number |
all} [wred-profile name]
To return to the default, use the no queue ingress multicast {linecard slot
number port-set number | all} [wred-profile name] command.
Parameters
linecard
port-set
all
1326
Introduced on the S4810.
Added support for multicast-bandwidth.
Introduced on the E-Series.
• A unique multicast weighted fair queuing (WFQ) setting can be applied only on a per
port-pipe basis. The minimum percentage of the multicast bandwidth assigned to any
of the ports in the port-pipe takes effect for the entire port-pipe.
• If the percentage of multicast bandwidth is 0, control traffic going through multicast
queues are dropped.
• The no form of the command without multicast-bandwidth and wred-
profile, removes both the wred-profile and multicast-bandwidth configuration.
• On 10 Gigabit ports only, the multicast bandwidth option works only if the total unicast
bandwidth is more than the multicast bandwidth.
• If strict priority is applied along with multicast-bandwidth, the effect of strict priority is
on all ports where unicast and multicast bandwidth are applied.
• When multicast bandwidth is assigned along with unicast bandwidth, first multicast
bandwidth is reserved for that port, then the remaining unicast bandwidth configured
is adjusted according to the bandwidth available after reserving for multicast
bandwidth.
– displays the egress queue statistics.
number
Enter the keyword linecard followed by the line card slot number.
For the E-Series, the range is 0 to 13 on a E1200, 0 to 6 on a E600/E600i,
and 0 to 5 on a E300.
number
Enter the keywords port-set followed by the line card's port pipe.
The range is 0 or 1.
Enter the keyword all to apply to all line cards.