Flow-Based Enable - Dell Force10 S4810P Reference Manual

Parameters
description
Defaults none
Command Modes MONITOR SESSION (conf-mon-
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.7.1.0
Version 7.5.1.0
pre-7.7.1.0
Related
monitor session
Commands

flow-based enable

Enable flow-based monitoring.
E-Series
Syntax flow-based enable
To disable flow-based monitoring, use the no flow-based enable command.
Defaults Disabled, that is flow-based monitoring is not applied.
Command Modes MONITOR SESSION (conf-mon-
Command History
Version 8.1.1.0
Version 7.4.1.0
Usage To monitor traffic with particular flows ingressing/egressing the interface, appropriate ACLs
Information can be applied in both ingress and egress direction.
Related
monitor session
Commands
1270
Enter a description regarding this session (80 characters maximum).
sess-session-ID )
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enables a monitoring session.
sess-session-ID )
Introduced on the E-Series ExaScale.
Introduced on the E-Series.
– enables a monitoring session.