private-vlan mapping secondary-vlan
Map secondary VLANs to the selected primary VLAN.
C-Series, S-Series, Z-Series, S4810
Syntax
[no] private-vlan mapping secondary-vlan vlan-list
To remove specific secondary VLANs from the configuration, use the no private-vlan
mapping secondary-vlan vlan-list command syntax.
Parameters
vlan-list
Defaults
none
Command Modes
INTERFACE VLAN
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Usage
The list of secondary VLANs can be:
Information
Related
private-vlan mode
Commands
show interfaces private-vlan
show vlan private-vlan
show vlan private-vlan mapping
switchport mode private-vlan
show interfaces private-vlan
Display type and status of PVLAN interfaces.
C-Series, S-Series
Syntax
show interfaces private-vlan [interface interface]
1280
Enter the list of secondary VLANs to associate with the selected
primary VLAN. The list can be in comma-delimited or hyphenated-
range format, following the convention for the range input.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
•
Specified in comma-delimited or hyphenated-range format.
•
Specified with this command even before they have been created.
•
Amended by specifying the new secondary VLAN to be added to the list.
– sets the mode of the selected VLAN to community, isolated, or primary.
– displays the type and status of the PVLAN interfaces.
– displays the PVLANs and/or interfaces that are part of a PVLAN.
– sets PVLAN mode of the selected port.
– displays the primary-secondary VLAN mapping.