Dell Force10 S4810P Reference Manual page 1595

Defaults 0x9100
Command Modes CONFIGURATION
Command History
Version 8.3.7.0
Version 8.2.1.0
Version 8.2.1.0
Version 7.6.1.0
E-Series original
Command
Usage
For specific interoperability limitations regarding the S-Tag TPID, refer to the
Information
Configuration Guide .
On E-Series TeraScale, the two characters you enter in the CLI for number become the MSB,
as shown below:
Number
1
10
More than two
characaters
On E-Series ExaScale, C-Series, and S-Series, four characters you enter in the CLI for number
are interpreted, as shown below:
Number
1
10
81
8100
Related
portmode hybrid
Commands
A port configured this way is identified as a hybrid port in report displays.
vlan-stack trunk
VLAN network.
Introduced on the S4810.
Introduced on the E-Series ExaScale. C-Series and S-Series accept
both bytes of the 2-byte S-Tag TPID.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Resulting TPID
0x0100
0x1000
Configuration rejected.
Resulting TPID
0x0001
0x0010
0x0081
0x8100
– sets a port (physical ports only) to accept both tagged and untagged frames.
– specifies a Layer 2 port or port channel as a trunk port to the Stackable
FTOS
1595