Show Fefd - Dell Force10 S4810P Reference Manual

To disable FEFD globally, use the no fefd-global [mode {normal |
aggressive}] command.
Parameters
normal
aggressive
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.12.0
Legacy E-Series
command.
Usage
If you enter only the fefd-global syntax, the mode is normal and the default interval is 15
Information
seconds.
If you disable FEFD globally (no fefd-global), the system does not remove the FEFD
interface configuration.
Related
Commands

show fefd

View FEFD status globally or on a specific interface.
E-Series, Z-Series, S4810
Syntax show fefd [interface]
Parameters
interface
1064
(OPTIONAL) Enter the keywords mode normal to change the link
state to "unknown" when a far-end failure is detected by the
software on that interface. When the interface is placed in
"unknown" state, the software brings down the line protocol. The
default is Normal mode.
(OPTIONAL) Enter the keywords mode aggressive to change the
link state to "error-disabled" when a far-end failure is detected by the
software on that interface. When an interface is placed in "error-
disabled" state, you must enter the fefd reset command to reset
the interface state.
Introduced on the Z9000.
Introduced on the S4810.
• fefd – enables far-end failure detection.
• fefd-global interval – configures an interval between FEFD control packets.
• show fefdshow fefd – shows the FEFD command output.
(OPTIONAL) Enter the following keywords and slot/port or number
information:
•
•
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a SONET interface, enter the keyword sonet followed by
the slot/port information.