Ip Rip Receive Version - Dell Force10 S4810P Reference Manual

Defaults Disabled.
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Related ip split-horizon
Commands

ip rip receive version

Set the interface to receive specific versions of RIP. The RIP version you set on the interface overrides the version
command in ROUTER RIP mode.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip rip receive version [1] [2]
To return to the default, use the no ip rip receive version command.
Parameters
1
2
Defaults RIPv1 and RIPv2
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage If you want the interface to receive both versions of RIP, use the ip rip receive
Information
version 1 2 command.
Related
ip rip send version
Commands
version
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– sets the RIP routing updates to exclude routing prefixes.
(OPTIONAL) Enter the number 1 for RIP version 1.
(OPTIONAL) Enter the number 2 for RIP version 2.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– sets the RIP version to be used for sending RIP traffic on an interface.
– sets the RIP version to be used for the switch software.
1361