Cam-Acl-Egress - Dell Force10 S4810P Reference Manual

Parameters
default
l2acl
1-10 ipv6acl 0-10
ipv4qos
l2qos
Command Modes CONFIGURATION
Command History
Version 8.3.7.0
Version 8.4.2.0
Version 8.2.1.0
Version 7.8.1.0
Usage
For the new settings to take effect, you must save the new CAM settings to the startup-config
Information
(write-mem or copy run start), then reload the system.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and
these cannot be reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are 1-10, except for the ipv6acl profile which is 0-10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).

cam-acl-egress

Allocate space for IPv6 egress ACLs.
C-Series, E-Series, S-Series, S4810
Syntax cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default
l2acl
1- 4 ipv6acl 0-4
902
Use the default CAM profile settings, and set the CAM as follows:
•
•
•
•
•
1-10 ipv4acl
Allocate space to support IPv6 ACLs. You must enter all of the profiles
and a range. Enter the CAM profile name followed by the amount to
1-10
be allotted. The total space allocated must equal 13. The ipv6acl
1-10
range must be a factor of 2.
Introduced on the S4810.
Introduced on the E-Series TeraScale.
Introduced on the S-Series.
Introduced on the C-Series.
Use the default CAM profile settings, and set the CAM as follows:
•
•
•
1-4 ipv4acl
Allocate space to support IPv6 ACLs. You must enter all of the profiles
and a range. Enter the CAM profile name followed by the amount to
be allotted. The total space allocated must equal 13. The ipv6acl
range must be a factor of 2.
L3 ACL (ipv4acl): 6
L2 ACL(l2acl): 5
IPv6 L3 ACL (ipv6acl): 0
L3 QoS (ipv4qos): 1
L2 QoS (l2qos): 1
L2 ACL(l2acl): 1
L3 ACL (ipv4acl: 1
IPv6 L3 ACL (ipv6acl): 2