ipv6 pim join-filter
Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the PIM-SM
router from creating state based on multicast source and/or group.
E-Series, S4810
Syntax
ipv6 pim join-filter access-list
Parameters
access-list
in
out
Defaults
none
Command Modes
INTERFACE
Command History
Version 8.3.12.0
Version 7.3.1.0
Example
FTOS(conf)#ipv6 access-list JOIN-FIL_ACL
FTOS(conf-ipv6-acl)#permit ipv6 165:87:34::0/112 ff0e::
225:1:2:0/112
FTOS(conf-ipv6-acl)#permit ipv6 any ff0e::230:1:2:0/112
FTOS(conf-ipv6-acl)#permit ipv6 165:87:32::0/112 any
FTOS(conf-ipv6-acl)#exit
FTOS(conf)#interface gigabitethernet 0/84
FTOS(conf-if-gi-0/84)#ipv6 pim join-filter JOIN-FIL_ACL in
FTOS(conf-if-gi-0/84)#ipv6 pim join-filter JOIN-FIL_ACL out
ipv6 pim neighbor-filter
Prevent the system from forming a PIM adjacency with a neighboring system.
E-Series, S4810
Syntax
ipv6 pim neighbor-filter {access-list}
Parameters
access-list
Defaults
none
Command Modes
CONFIGURATION
Command History
Version 8.3.12.0
Version 8.3.1.0
Usage
Do not enter this command before creating the access-list.
Information
1260
Enter the name of an extended access list.
Enter the keyword in to apply the access list to inbound traffic.
Enter the keyword out to apply the access list to outbound traffic.
Introduced on the S4810.
Introduced
Enter the name of a standard access list. Maximum 16 characters.
Introduced on the S4810.
Introduced