Dell Force10 S4810P Reference Manual page 1256

Field
expires
RP
flags
Incoming interface
RPF neighbor
Outgoing interface
list:
Example
FTOS#show ip pim tib
PIM Multicast Routing Table
Flags:D- Dense, S- Sparse, C- Connected, L- Local, P- Pruned,
SPT,
Advertisement,
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(*, 226.1.1.1), uptime 01:29:19, expires 00:00:52, RP
10.211.2.1, flags: SCJ
10.211.1.2
(*, 226.1.1.2), uptime 00:18:08, expires 00:00:52, RP
10.211.2.1, flags: SCJ
10.211.1.2
1256
Description
Displays the amount of time until the entry expires and is removed
from the database.
Displays the IP address of the RP/source for this entry.
List the flags to define the entries:
•
•
•
•
•
•
•
•
•
•
Displays the reverse path forwarding (RPF) interface towards the RP/
source.
Displays the next hop from this interface towards the RP/source.
Lists the interfaces that meet one of the following criteria:
•
•
•
R- RP-bit set, F- Register flag, T- SPT-bit set, J- Join
M- MSDP created entry, A- Candidate for MSDP
K- Ack-Pending State
Incoming interface: GigabitEthernet 4/23, RPF neighbor
Outgoing interface list:
GigabitEthernet 8/0
Incoming interface: GigabitEthernet 4/23, RPF neighbor
Outgoing interface list:
D = PIM Dense Mode
S = PIM Sparse Mode
C = directly connected
L = local to the multicast group
P = route was pruned
R = the forwarding entry is pointing toward the RP
F = FTOS is registering this entry for a multicast source
T = packets were received via Shortest Tree Path
J = first packet from the last hop router is received and the
entry is ready to switch to SPT
K = acknowledge pending state
a directly connect member of the Group
statically configured member of the Group
received a (*,G) Join message