Dell Force10 S4810P Reference Manual page 1065

Command Modes
Command History
Version 8.3.11.1
Version 8.3.12.0
Legacy E-Series
command.
Usage The following describes the show fefd command shown in the Example below.
Information
Field
Interface
Mode
Interval
State
Example
FTOS#sh fefd
FEFD is globally 'ON', interval is 10 seconds, mode is
'Aggressive'.
INTERFACE MODE
Gi 5/0
Gi 5/1
Gi 5/2
Gi 5/3
Gi 5/4
•
•
•
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Description
Displays the interfaces type and number.
Displays the mode (aggressive or normal) or NA if the interface
contains fefd reset in its configuration.
Displays the interval between FEFD packets.
Displays the state of the interface and can be one of the following:
•
•
•
•
•
Aggressive
Aggressive
Aggressive
Aggressive
Aggressive
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/ port information.
bi-directional (interface is up and connected and ing
neighbor's echoes).
err-disabled (only found when the FEFD mode is aggressive
and when the interface has not n its neighbor's echoes for 3
times the message interval. To reset an interface in this
state, use the fefd reset command.)
unknown (only found when FEFD mode is normal.
locally disabled (interface contains the fefd reset
command in its configuration).
Admin Shutdown (interface is disabled with the shutdown
command).
INTERVAL STATE
(second)
10 Admin Shutdown
10 Admin Shutdown
10 Admin Shutdown
10 Admin Shutdown
10 Admin Shutdown
1065