Dell Force10 S4810P Reference Manual page 1206

Parameters
process-id
Command Modes
Command History
Version 9.1(0.0)
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage The following describes the show ip ospf process-id virtual-links command
Information shown in the Example below.
Items
"Virtual Link..."
"Run as..."
"Transit area..."
"Transmit Delay..."
"Timer intervals..."
"Hello due..."
"Adjacency State..."
Example
FTOS#show ip ospf 1 virt
Virtual Link to router 192.168.253.5 is up
Cost of using 2
Retransmit 5
FTOS#
1206
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
• EXEC
• EXEC Privilege
Deprecated command on the S4810 and Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
This line specifies the OSPF neighbor to which the virtual link was
created and the link's status.
This line states the nature of the virtual link.
This line identifies the area through which the virtual link was
created, the interface used, and the cost assigned to that link.
This line displays the transmit delay assigned to the link and the
State of the OSPF neighbor.
This line displays the timer values assigned to the virtual link. The
timers are Hello is hello-interval, Dead is dead-interval, Wait is
transmit-delay, and Retransmit is retransmit-interval.
This line displays the amount of time until the next Hello packet is
expected from the neighbor router.
This line displays the adjacency state between neighbors.
Run as demand circuit
Transit area 0.0.0.1, via interface GigabitEthernet 13/16,
Transmit Delay is 1 sec, State POINT_TO_POINT,
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Hello due in 00:00:02