Storm-Control Unknown-Unicast (Interface) - Dell Force10 S4810P Reference Manual

storm-control unknown-unicast (Interface)

Configure percentage of unknown-unicast traffic allowed on an interface (ingress only).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax storm-control unknown-unicast [percentage decimal_value in] |
[wred-profile name]] [packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-control
unknown-unicast [percentage decimal_value in] | [wred-profile
name]] [packets_per_second in] command.
Parameters
percentage
decimal_value [in
| out]
wred-profile
name
packets_per_sec
ond in
Defaults none
Command Modes INTERFACE (conf-if-
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.1.0
E-Series Only: Enter the percentage of broadcast traffic allowed in or
out of the network. Optionally, you can designate a decimal value
percentage, for example, 55.5%.
Percentage: 0 to 100:
• 0% blocks all related traffic.
• 100% allows all traffic into the interface.
The decimal range is .1 to .9.
E-Series Only: (Optionally) Enter the keywords wred-profile
followed by the profile name to designate a wred-profile.
C-Series and S-Series Only: Enter the packets per second of
broadcast traffic allowed into the network. The range is 0 to 33554431.
interface-slot/port )
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
E-Series Only: Added the percentage decimal value option.
Introduced on the E-Series.
1537