Ipv6 Pim Rp-Address; Ipv6 Pim Rp-Candidate - Dell Force10 S4810P Reference Manual

ipv6 pim rp-address

Configure a static PIM rendezvous point (RP) address for a group. This address is used by first-hop routers to send
register packets on behalf of the source multicast host.
E-Series, S4810
Syntax ipv6 pim rp-address address group-address group-address mask
override
To remove an RP address, use the no ipv6 pim re-address address group-
address mask override command.
Parameters
address
group-address
group-address
mask
override
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0
Version 7.4.1.0
Usage
The RP addresses are stored in the order in which they are entered. RP addresses learnt via
Information
BSR take priority over static RP addresses.
Without the override option, RPs advertised by the BSR updates take precedence over the
statically configured RPs.

ipv6 pim rp-candidate

Specify an interface as an RP candidate.
E-Series, S4810
Syntax ipv6 pim rp-candidate interface [priority-value]
1262
Enter the IPv6 RP address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
Enter the keywords group-address followed by the group
address in the x:x:x:x::x format and then the mask in /nn format to
assign that group address to the RP.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
Enter the keyword override to override the BSR updates with
static RP. The override takes effect immediately during enable/
disable.
NOTE: This option is applicable to multicast group range.
Introduced on the S4810.
Introduced