Virtual Router Redundancy Protocol (VRRP)
Virtual router redundancy protocol (VRRP) is supported by the Dell Force10 operating system (FTOS) on all Dell Force10
C-Series, E-Series, S-Series, Z-Series, or S4810 platforms.
IPv4 VRRP Commands
The following are IPv4 VRRP commands.
advertise-interval
Set the time interval between VRRP advertisements.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
advertise-interval seconds
To return to the default settings, use the no advertise-interval command.
Parameters
seconds
Defaults
1 second
Command Modes
INTERFACE-VRRP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage
Dell Force10 recommends keeping the default setting for this command. If you do change the
Information
time interval between VRRP advertisements on one router, you must change it on all routers.
Enter a number of seconds. The range is 1 to 255. The default is 1
second.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
59
1613