Ip Pim Rp-Candidate - Dell Force10 S4810P Reference Manual

override
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
pre-Version
6.1.1.1
Usage This address is used by first-hop routers to send register packets on behalf of source multicast
Information hosts. The RP addresses are stored in the order in which they are entered. RP addresses
learned using BSR take priority over static RP addresses. Without the override option, RPs
advertised by the BSR updates take precedence over the statically configured RPs.

ip pim rp-candidate

Configure a PIM router to send out a Candidate-RP-Advertisement message to the bootstrap (BS) router or define group
prefixes that are defined with the RP address to PIM BSR.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip pim rp-candidate {interface [priority]
To return to the default value, use the no ip pim rp-candidate {interface
[priority] command.
Parameters
interface
Enter the keyword override to override the BSR updates with
static RP. The override takes effect immediately during enable/
disable.
NOTE: This option is applicable to multicast group range.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the E-Series.
Enter the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/ port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
1243