Command History
Version 8.3.11.1
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Example
FTOS(conf-if-po-1)#show config
!
interface Port-channel 1
FTOS(conf-if-po-1)#
show interfaces port-channel
Display information on configured Port Channel groups.
C-Series, E-Series, S-Series, Z-Series
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
channel-number
brief
Command Modes
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
The following describes the show interfaces port-channel command shown in the
Information
Example below.
824
Introduced on the Z9000.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
no ip address
shutdown
For a Port Channel interface, enter the keyword port-channel
followed by a number. For the C-Series and S-Series, the range is 1 to
128. For the E-Series, the range is 1 to 255 for TeraScale and 1 to 512
for ExaScale.
(OPTIONAL) Enter the keyword brief to display only the port
channel number, the state of the port channel, and the number of
interfaces in the port channel.
•
EXEC
•
EXEC Privilege
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series. Modified to display the LAG failover
group status.
Introduced on the C-Series.