Match Ip Precedence - Dell Force10 S4810P Reference Manual

set-ip-dscp
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.1
Usage
You must enter the class-map command in order to access this command. After the class
Information
map is identified, you can configure the match criteria.
The match ip dscp and match ip precedence commands are mutually exclusive.
Up to 64 IP DSCP values can be matched in one match statement. For example, to indicate IP
DCSP values 0 1 2 3 4 5 6 7, enter either the match ip dscp 0,1,2,3,4,5,6,7 or
match ip dscp 0-7 command.
Related class-map
Commands

match ip precedence

Use IP precedence values as a match criteria.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax match ip precedence ip-precedence-list [[multicast] set-ip-dscp
value]
To remove IP precedence as a match criteria, use the no match ip precedence ip-
precedence-list [[multicast] set-ip-dscp value] command.
Parameters
ip-precedence-
list
value
(OPTIONAL) Enter the keywords set-ip-dscp followed by the IP
DSCP value. The matched traffic is marked with the DSCP value. The
range is 0 to 63.
NOTE: This option is not supported on S-Series.
Introduced on the Z9000.
Introduced on the S4810.
Added the keyword multicast. Added the DSCP Marking
option support on the S-Series.
Introduced on the S-Series.
Introduced on the C-Series. Added support for the DSCP Marking
option.
Introduced on the E-Series.
NOTE: Only one of the IP DSCP values must be a successful match criterion, not all of the
specified IP DSCP values need to match.
– identifies the class map.
Enter the IP precedence value(s) as the match criteria. Separate
values by commas — no spaces ( 1,2,3 ) or indicate a list of values
separated by a hyphen (1-3). The range is 0 to 7.
1317