Ipv6 Route Map Commands; Match Ipv6 Address; Match Ipv6 Next-Hop - Dell Force10 S4810P Reference Manual

2 port-set 1
Linecard|Portpipe| CAM Partition|Available CAM|Estimated CAM
per Port|Status
---------------------------------------------------------------
--
Allowed
Allowed
FTOS#

IPv6 Route Map Commands

The following commands allow you to configure route maps and their redistribution criteria.

match ipv6 address

Configure a filter to match routes based on IPv6 addresses specified in an access list.
C-Series, E-Series, S-Series
Syntax match ipv6 address prefix-list-name
To delete a match, use the no match ipv6 address prefix-list-name command.
Parameters
prefix-list-name
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.4.2.1
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
Related

match ipv6 next-hop

Commands
match ipv6 route-source
match ipv6 next-hop
Configure a filter which matches based on the next-hop IPv6 addresses specified in the IPv6 prefix list.
C-Series, E-Series, S-Series
Syntax match ipv6 next-hop prefix-list prefix-list-name
2| 1| IPv4Flow|
2| 1| IPv6Flow|
Enter the name of IPv6 prefix list, up to 140 characters.
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
Introduced on the C-Series. Increased the name string to accept up
to 140 characters. Prior to version 7.8.1.0, the names are up to 16
characters long.
Introduced on the E-Series TeraScale.
– redistributes routes that match the next-hop IP address.
– redistributes routes that match routes advertised by other routers.
232|
0|
0|
0|
929