Ipv6 Pim Bsr-Candidate - Dell Force10 S4810P Reference Manual

Parameters
bsr
events
group
packet
register [
state
timer [assert |
hello | joinprune |
register]
Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 8.3.12.0
Version 7.4.1.0

ipv6 pim bsr-candidate

Configure the router as a bootstrap (BSR) candidate.
E-Series, S4810
Syntax ipv6 pim bsr-candidate interface [hash-mask-length] [priority]
To disable the bootstrap candidate, use the no ipv6 pim bsr-candidate command.
Parameters
interface
1258
(OPTIONAL) Enter the keyword bsr to invoke debugging of IPv6 PIM
Candidate RP/BSR activities.
(OPTIONAL) Enter the keyword events to invoke debugging of IPv6
PIM events.
group
(OPTIONAL) Enter the keyword group followed by the group address
to invoke debugging on that specific group.
(OPTIONAL) Enter the keyword packet to invoke debugging of IPv6
PIM packets.
group ]
(OPTIONAL) Enter the keyword register and optionally the group
address to invoke debugging of IPv6 PIM register messages for a
particular group.
(OPTIONAL) Enter the keyword state to view IPv6 PIM state
changes.
(OPTIONAL) Enter the keyword timer to view IPv6 PIM timers. Enter
one of the optional parameters:
• assert: to view the assertion timer
• hello: to view the IPv6 PIM neighbor keepalive timer
• joinprune: to view the expiry timer (join/prune timer)
• register: to view the register suppression timer
Introduced on the S4810.
Introduced
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.