Show Arp - Dell Force10 S4810P Reference Manual

static routes and the Management Connected prefix are not reflected in the hardware routing
tables. Separate routing tables are maintained for IPv4 and IPv6 management routes. This
command manages both tables.
Related
interface ManagementEthernet
Commands
Primary or Standby RPM).
duplex (Management)
speed (Management interface)

show arp

Display the ARP table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show arp [vrf vrf name][interface interface | ip ip-address
[mask] | macaddress mac-address [mac-address mask]] [cpu {cp |
rp1 | rp2}] [static | dynamic] [summary]
Parameters
vrf name
cpu
interface
interface
– configures the Management port on the system (either the
– sets the mode of the Management interface.
– sets the speed for the Management interface.
E-Series Only: Show only the ARP cache entries tied to the VRF
process.
(OPTIONAL) Enter the keyword cpu with one of the following
keywords to view ARP entries on that CPU:
• cp - view ARP entries on the control processer.
• rp1 - view ARP entries on Routing Processor 1.
• rp2 - view ARP entries on Routing Processor 2.
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For the Management interface, enter the keyword
managementethernet followed by the slot/port
information.
• For a Port Channel interface, enter the keyword port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
869