Spanning Tree Protocol (Stp); Bridge-Priority - Dell Force10 S4810P Reference Manual

Spanning Tree Protocol (STP)

The commands in this chapter configure and monitor the IEEE 802.1d spanning tree protocol (STP) and are supported on
the C-series, E-Series, S-series, Z-Series, or S4810 Dell Force10 switch/routing platforms.

bridge-priority

Set the bridge priority of the switch in an IEEE 802.1D spanning tree.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax bridge-priority {priority-value | primary | secondary}
To return to the default value, use the no bridge-priority command.
Parameters
priority-value
primary
secondary
Defaults priority-value = 32768
Command Modes SPANNING TREE (The prompt is "config-stp".)
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Enter a number as the bridge priority value. The range is 0 to 65535.
The default is 32768.
Enter the keyword primary to designate the bridge as the root
bridge.
Enter the keyword secondary to designate the bridge as a
secondary root bridge.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
53
1539