Output-Delay - Dell Force10 S4810P Reference Manual

Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage When the offset metric is applied to an interface, that value takes precedence over an offset
Information value that is not extended to an interface.
Related ip prefix-list
Commands

output-delay

Set the interpacket delay of successive packets to the same neighbor.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax output-delay delay
To return to the switch software defaults for interpacket delay, use the no output-delay
command.
Parameters
delay
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
1366
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enters PREFIX-LIST mode and configure a prefix list.
Specify a number of milliseconds as the delay interval. The range is 8
to 50.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.