Dell Force10 S4810P Reference Manual page 951

configured
gigabitethernet
linecard
number
managementethe
rnet
loopback
port-channel
tengigabitetherne
t
fortyGigE
vlan
Defaults none
Command Modes
Command History
Version 9.0.0.0
Version 8.3.7.0
Version 8.5.1.0
Version 8.4.2.1
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
Usage The Management port is enabled by default (no shutdown). If necessary, use the ipv6
Information address command to assign an IPv6 address to the Management port.
Example
FTOS#
FTOS#show ipv6 int te 0/5
TenGigabitEthernet 0/5 is up, line protocol is up
(OPTIONAL) View information on all IPv6 configured interfaces.
(OPTIONAL) View information for an IPv6 gigabitethernet interface.
slot-
(OPTIONAL) View information for a specific IPv6 linecard or S-Series
stack-unit:
•
•
•
•
(OPTIONAL) View information on an IPv6 Management port. Enter the
slot/ port
slot number (0-1) and port number zero (0).
(OPTIONAL) View information for IPv6 loopback interfaces.
(OPTIONAL) View information for IPv6 port channels.
(OPTIONAL) View information for an IPv6 tengigabitethernet
interface.
(OPTIONAL) View information for an IPv6 fortygigabitethernet
interface.
(OPTIONAL) View information for IPv6 VLANs.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S-Series.
Introduced on the E-Series ExaScale. Added support for the
managementethernet slot/port parameter.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
IPV6 is enabled
Link Local address: fe80::201:e8ff:fe8a:e8f7
Global Unicast address(es):
The range is 0 to 13 on a E1200, 0 to 6 on a E600, and 0 to 5 on
a E300
The range is 0 to 7 for C-Series
The range is 0 to 7 for S55 only
The range is 0 to 11 for S60 and S4810
951