Ipv6 Ospf Cost - Dell Force10 S4810P Reference Manual

To remove an IPsec authentication policy from an interface, enter the no ipv6 ospf
authentication spi
the interface to inherit the authentication policy configured for the OSPFv3 area, enter the no
ipv6 ospf authentication null command.
Related
area
Commands
authentication
show crypto
ipsec policy
show crypto
ipsec sa ipv6

ipv6 ospf cost

Explicitly specify the cost of sending a packet on an interface.
C-Series, E-Series, Z-Series, S4810
Syntax ipv6 ospf interface-cost
Parameters
interface-cost
Defaults Default cost based on the bandwidth.
Command Modes INTERFACE
Command History
Version 9.1.(0.0)
Version 7.8.1.0
Version 7.4.1.0
Usage
In general, the path cost is calculated as:
Information
10^8 / bandwidth
Using this formula, the default path cost are calculated as:
number command. To remove null authentication on an interface to allow
Configure an IPsec authentication policy for an OSPFv3 area.
Display the configuration of IPsec authentication policies.
Display the security associations set up for OSPFv3 interfaces in
authentication policies.
Enter a unsigned integer value expressed as the link-state metric.
Range: 1 to 65535
Introduced on the S4810 and Z9000.
Added support for C-Series.
Introduced on the E-Series.
• GigabitEthernet—Default cost is 1
• TenGigabitEthernet—Default cost is 1
• FortygigEthernet — Default cost is 1
• Ethernet—Default cost is 10
1219