Name - Dell Force10 S4810P Reference Manual

SNMP counters differ from show interface counters as SNMP counters must maintain history.
At any point, the value of SNMP counters reflect the amount of traffic being carried on the
VLAN.
VLAN output counters may show higher than expected values because source-suppression
drops are counted.
During an RPM failover event, all SNMP counters remain intact. The counters sync over to the
secondary RPM.
Example
The bold lines show enabling VLAN output reveals the output statistics counters for the VLAN.
FTOS(conf)#enable vlan-output-counters
FTOS(conf)#exit
FTOS#show interface vlan 101
Vlan 101 is down, line protocol is down
Address is 00:01:e8:26:e0:5b, Current address is
00:01:e8:26:e0:5b
Interface index is 1107787877
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 01:12:44
Queueing strategy: fifo
Input Statistics:
Output Statistics:
Time since last interface status change: 01:12:44
FTOS#
FTOS#show interfaces vlan 1
Vlan 1 is down, line protocol is down
Address is 00:01:e8:13:a5:aa, Current address is
00:01:e8:13:a5:aa
Interface index is 1107787777
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 01:36:01
Queueing strategy: fifo
Input Statistics:
Output Statistics:
Time since last interface status change: 01:36:01
FTOS#

name

Assign a name to the VLAN.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax name vlan-name
To remove the name from the VLAN, use the no name command.
Parameters
vlan-name
0 packets, 0 bytes
0 packets, 0 bytes
100000 packets, 10000000 bytes
200000 packets, 20800000 bytes
Enter up to 32 characters as the name of the VLAN.
1051