Ip Msdp Peer - Dell Force10 S4810P Reference Manual

ip msdp peer

Configure an MSDP peer.
E-Series, Z-Series, S4810
Syntax ip msdp peer peer address [connect-source] [description] [sa-
limit number]
To remove the MSDP peer, use the no ip msdp peer peer address [connect-
source interface] [description name] [sa-limit number] command.
Parameters
peer address
connect-source
interface
description name
sa-limit
Defaults as above
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.5.1.0
Version 7.5.1.0
Enter the peer address in a dotted decimal format (A.B.C.D.).
Enter the keywords connect-source followed by one of the
interfaces and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/ port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the E-Series, the range
is 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
(OPTIONAL) Enter the keyword
name (maximum 80 characters) to designate a description for the
MSDP peer.
number
(OPTIONAL) Enter the maximum number of SA entries in SA-cache.
The range is 1 to 500000. The default it 500000.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Added option for SA upper limit and the description option.
description followed by a description
1093