Show Interfaces Configured - Dell Force10 S4810P Reference Manual

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)
Hide thumbs Also See for Force10 S4810P:
Table of Contents

Advertisement

Time since last interface status change: 00:05:12
Related

show interfaces configured

Commands
show interfaces linecard
show interfaces phy
show interfaces rate
interface.
show interfaces switchport
show inventory (C-Series and E-Series)
media), FTOS version including hardware identification numbers, and configured protocols.
show inventory (S-Series and Z-Series)
components (including media), FTOS version including hardware identification numbers, and
configured protocols.
show ip interface
show linecard
show range
show interfaces configured
Display any interface with a non-default configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show interfaces configured
Command Modes
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.4.1.0
Example
FTOS#show interfaces configured
GigabitEthernet 13/18 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:05:f7:fc
Interface index is 474791997
Internet address is 1.1.1.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 00:12:42
Queueing strategy: fifo
Input Statistics:
– displays any interface with a non-default configuration.
– displays information on all interfaces on a specific line card.
– displays information of either rate limiting or rate policing on the
– displays Layer 2 information about the interfaces.
– displays Layer 3 information about the interfaces.
– displays the line card(s) status.
– displays all interfaces configured using the interface range command.
EXEC
EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Changed the organization of the display output.
Current address is 00:01:e8:05:f7:fc
– displays the chassis type, components (including
– displays the S-Series and Z-Series switch types,
795

Advertisement

Table of Contents
loading

Table of Contents