Speed (Management Interface) - Dell Force10 S4810P Reference Manual

When you configure a speed for the 10/100/1000 interface, you should confirm the negotiation
auto command setting. Both sides of the link must have auto-negotiation either enabled or
disabled. For speed settings of 1000 or auto, the software sets the link to auto-negotiation and
you cannot change that setting.
In FTOS, the command speed 100 is an exact equivalent of speed auto 100 in IOS.
Related
duplex (10/100 Interfaces)
Commands
to 10/100.
negotiation auto

speed (Management interface)

Set the speed for the Management interface.
C-Series, E-Series, Z-Series, S4810
speed {10 | 100 | auto}
Syntax
To return to the default setting, use the no speed {10 | 100} command.
Parameters
10
100
auto
Defaults auto
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.11.1
Version 8.1.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Usage This command is found on the Management interface only.
Information
Related
interface ManagementEthernet
Commands
Primary or Standby RPM).
duplex (10/100 Interfaces)
to 10/100.
NOTE: Starting with FTOS version 7.8.1.0, when you use a copper SFP2 module with
catalog number GP-SFP2-1T in the S25P model of the S-Series, you can manually set its
speed with the speed command. When you set the speed to 10 or 100 Mbps, you can also
use the duplex command.
– configures duplex mode on physical interfaces with the speed set
– enables or disables auto-negotiation on an interface.
Enter the keyword 10 to set the interface's speed to 10 Mb/s.
Enter the keyword 100 to set the interface's speed to 10/100 Mb/s.
Enter the keyword auto to set the interface to auto-negotiate its
speed.
Introduced on the Z9000.
Introduced on the S55, S60, and S4810
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.
– configures duplex mode on physical interfaces with the speed set
– configures the Management port on the system (either the
815