general
root
Command Modes
EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage
When you enable debug spanning-tree bpdu for multiple interfaces, the software only
Information
sends information on BPDUs for the last interface specified.
Related
protocol spanning-tree
Commands
description
Enter a description of the spanning tree.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
description {description}
To remove the description from the spanning tree, use the no description
{description} command.
Parameters
description
Defaults
none
Command Modes
SPANNING TREE (The prompt is "config-stp".)
Command History
Version 8.3.11.1
Version 8.3.7.0
pre-Version
7.7.1.0
Related
protocol spanning-tree
Commands
(OPTIONAL) Enter the keyword general to debug general STP
operations.
(OPTIONAL) Enter the keyword root to debug STP root transactions.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enters SPANNING TREE mode on the switch.
Enter a description to identify the Spanning Tree (80 characters
maximum).
Introduced on the Z9000.
Introduced on the S4810.
Introduced
– enters SPANNING TREE mode on the switch.
1541