Dell Force10 S4810P Reference Manual page 1015

Parameters
interface
Command Modes
Command History
Version 8.3.12.0
Usage The following describes the show isis traffic command shown in the Example below.
Information
Item
Level-1/Level-2
Hellos (sent/rcvd)
PTP Hellos (sent/
rcvd)
Level-1/Level-2 LSPs
sourced (new/
refresh)
Level-1/Level-2 LSPs
flooded (sent/rcvd)
Level-1/Level-2 LSPs
CSNPs (sent/ rcvd)
Level-1/Level-2 LSPs
PSNPs (sent/ rcvd)
Level-1/Level-2 DR
Elections
Level-1/Level-2 SPF
Calculations
(OPTIONAL) Identifies the interface type slot/port as one of the
following:
•
•
•
•
•
• EXEC
• EXEC Privilege
Introduced on the S4810.
Description
Displays the number of Hello packets sent and received.
Displays the number of point-to-point Hellos sent and received.
Displays the number of new and refreshed LSPs.
Displays the number of flooded LSPs sent and received.
Displays the number of CSNP LSPs sent and received.
Displays the number of PSNP LPSs sent and received.
Displays the number of times designated router elections ran.
Displays the number of shortest path first calculations.
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
For a SONET interface, enter the keyword sonet followed by
the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
1015