Dell Force10 S4810P Reference Manual page 884

brief
linecard
number
configuration
Command Modes
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 8.1.1.2
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show ip interface command shown in the Example below.
Information
884
•
•
•
•
•
(OPTIONAL) Enter the keyword brief to view a brief summary of the
interfaces and whether an IP address is assigned.
slot-
(OPTIONAL) Enter the keyword linecard followed by the number
of the line card slot. For the C-Series, the range is 0-7. For the E-
Series, the range is 0 to 13 on a E1200/1200i, 0 to 6 on a E600/E600i,
and 0 to 5 on a E300.
NOTE: This keyword is not available on the S-Series.
(OPTIONAL) Enter the keyword configuration to display the
physical interfaces with non-default configurations only.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Supported on the E-Series ExaScale E600i.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
For a SONET interface, enter the keyword sonet followed by
the slot/ port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
(OPTIONAL) Enter an in or out parameter in conjunction
with the optional interface.
For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.