Dell Force10 S4810P Reference Manual page 1034

dynamic
station-move
Defaults
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.12.0
Version 8.3.7.0
Version 8.3.1.0
Version 8.2.1.0
Version 7.7.1.0
Version 6.5.1.0
Usage
This command and its options are supported on physical interfaces, static LAGs, LACP LAGs,
Information
and VLANs.
If you do not specify the vlan option, the MAC address counters is not VLAN-based. That is,
the sum of the addresses learned on all VLANs (not having any learning limit configuration) is
counted against the MAC learning limit.
MAC Learning Limit violation logs and actions are not available on a per-VLAN basis.
With the keyword no-station-move option, MAC addresses learned through this feature
on the selected interface persist on a per-VLAN basis, even if received on another interface.
Enabling or disabling this option has no effect on already learned MAC addresses.
After the MAC address learning limit is reached, the MAC addresses do not age out unless you
add the dynamic option. To clear statistics on MAC address learning, use the clear
counters command with the learning-limit parameter.
When a channel member is added to a port-channel and there is not enough ACL CAM space,
the MAC limit functionality on that port-channel is undefined. When this occurs, un-configure
the existing configuration first and then reapply the limit with a lower value.
Related
clear counters
Commands
1034
(OPTIONAL) Enter the keyword dynamic to allow aging of MACs
even though a learning limit is configured.
(OPTIONAL) Enter the keywords station-move to allow a station
move on learned MAC addresses.
• On C-Series, the default behavior is no-station-move + static.
• On E-Series, the default behavior is station-move + static.
• On S-Series, the default behavior is dynamic.
NOTE: "Static" means manually entered addresses, which do not age.
Introduced on the Z9000.
Deprecated the no-station-move command (replaced by the
mac-learning-limit mac-address-sticky command).
Introduced on the S4810.
Added the vlan option on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series. Added the station-move option.
Added support for MAC Learning-Limit on the LAG.
NOTE: If you configure this command on an interface in a routed VLAN, and after the MAC
addresses learned reaches the limit set in the mac learning-limit command, IP
protocols are affected. For example, VRRP sets multiple VRRP Masters and OSPF may not
come up.
– Clear counters used in the show interface command.