Show Mac Cam - Dell Force10 S4810P Reference Manual

Version 8.3.7.0
pre-Version
6.2.1.1
Usage MAC Accounting information can be accessed using SNMP via the Force10 Monitor MIB. For
Information more information about enabling SNMP, refer to the
Example
FTOS-1#sh mac accounting destination interface gigabitethernet
2/1
Destination
00:44:00:00:00:02
00:44:00:00:00:01
00:22:00:00:00:00
00:44:00:00:00:02
00:44:00:00:00:01
FTOS-1#
Related show mac accounting access-list
Commands (if configured).

show mac cam

Display the CAM size and the portions allocated for MAC addresses and for MAC ACLs.
E-Series
Syntax show mac cam
Command Modes
Command History
pre-Version
6.2.1.1
Usage The following describes the show mac cam command shown in the Example below.
Information
Field
Slot
Type
MAC CAM Size
1046
Introduced on the S4810.
Introduced on the E-Series.
NOTE: Currently, the Force10 MONITOR MIB does not return the MAC addresses in an
increasing order using SNMP. As a workaround, you can use the -C c option in
snmpwalk or snmpbulkwalk to access the Force10 MONITOR MIB. For example: %
snmpwalk -C c -v 2c -c public 133.33.33.131 enterprise.6027.3.3.3
Out Port
Te
Te
Te
Te
Te
• EXEC
• EXEC Privilege
Introduced on the E-Series.
Description
Lists the active line card slots.
Lists the type of line card present in the slot.
Displays the total CAM size available.
FTOS Configuration Guide .
VLAN Packets Bytes
11/0 1000 10000
11/0 1000 10000
11/0 1000 10000
11/0 2000 10000
11/0 2000 10000
– displays the MAC access list configurations and counters
5120000
5120000
5120000
5120000
5120000