Dell Force10 S4810P Reference Manual page 789

Command History
Version 9.1(0.0)
Version 8.3.12.1
Version 8.3.11.4
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 8.2.1.2
Version 8.2.1.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.4.1.0
Version 6.3.1.0
Usage
Use the show interfaces command for details on a specific interface. Use the show
Information
interfaces linecard command for details on all interfaces on the designated line card.
On the S4810, the show interface output displays incorrect rate information details over
time for link monitoring when the rate-interval is configured for 5 seconds. Dell Force10
recommends using higher rate-intervals such as 15 to 299 seconds to minimize the errors seen.
User Information
The following table describes the show interfaces command shown in the 10G
(TeraScale) Example below.
Line
TenGigabitEthernet
0/0...
• EXEC Privilege
Updated ManagementEthernet output to include two global IPv6
addresses on S4810 and Z9000 and added output example showing
OpenFlow instance ID.
Updated command output to support multiple IPv6 addresses on
S4810.
Output expanded to support eSR4 optics in Z9000.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Included SFP and SFP+ optics power detail in the E-Series and C-
Series output.
Added support for 4093 VLANs on the E-Series ExaScale. Prior
releases supported 2094.
Introduced on the E-Series ExaScale.
Output expanded to include SFP+ media on the C-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Changed the organization of the display output.
Added the Pluggable Media Type field in the E-Series TeraScale
output.
NOTE: In the CLI output, the power value is rounded to a 3-digit value. For receive/transmit
power that is less than 0.000, an snmp query returns the corresponding dbm value even
though the CLI displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until it reaches
the maximum line rate. When the maximum line rate is reached, there is no change in the
line-rate.
Description
Interface type, slot/port, and administrative and line protocol status.
789