pre-Version
6.2.1.1
Usage
To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual
Information
address with same IP address as the interface's primary IP address and change the priority of
the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal to the
interface's primary IP address, an error message appears.
show config
View the non-default VRRP configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config [verbose]
Parameters
verbose
Command Modes
VRRP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Example
FTOS(conf-if-vrid-4)#show con
vrrp-group 4
!
show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the FTOS returns No Active VRRP group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show vrrp [vrrp-id] [interface] [brief]
Parameters
vrrp-id
interface
Introduced on the E-Series.
(OPTIONAL) Enter the keyword verbose to view all VRRP group
configuration information, including defaults.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
virtual-address 119.192.182.124
(OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to
view only that group. The range is 1 to 255.
(OPTIONAL) Enter the following keywords and slot/port or number
information:
1619